Xerox 5222 - Manual (Page 49)

Copy
49
Stopping a Copy Job
Follow the steps below to manually cancel an activated copy job.
1. Press the button on the
control panel to suspend the
current copy job.
2. If required, press the Status> button to display the
[Active Jobs] tab. To exit the
[Active Jobs] tab, press the
button.
3. On the [Stop/Pause] screen
displayed, select [Cancel] to delete the suspended copy job.
NOTE: To resume the job, select [Resume] on the [Stop/Pause] screen.
Copy
This section describes the features on the [Copy] screen. For information on the
features available, refer to the following:
Reduce/Enlarge – page 49
Paper Supply – page 51
2 Sided Copying – page 52
Copy Output – page 53
1. Press the button
on the control panel.
2. Select [Copy] on the touch
screen.
3. Set the required feature.
4. Select [Save].
Reduce/Enlarge
This feature allows you to reduce or enlarge copies by a specified ratio within the range
of 25-400%.
1. Select the [Reduce/Enlarge]
feature on the [Copy] screen.
button