ZyXEL Communications ES-315 - Manual (Page 94)

Chapter 15 Maintenance
ES-315/ES-315-F User’s Guide
94
15.2 Load Factory Default
Follow the steps below to reset the Switch back to the factory defaults.
1 In the Maintenance screen, click the Click Here button next to Load Factory Default
to clear all Switch configuration information you configured and return to the factory
defaults.
2 Click OK to reset all Switch configurations to the factory defaults.
Figure 45 Load Factory Default: Start
3 In the web configurator, click the Save button to make the changes take effect. If you
want to access the Switch’s web configurator again, you may need to change the IP
address of your computer to be in the same subnet as that of the default Switch IP
address (192.168.1.1).
15.3 Save Configuration
Click Config 1 to save the current configuration settings permanently to the Switch.
Alternatively, click Save on the top right-hand corner in any screen to save the configuration
changes to the current configuration.
"
Clicking the Apply or Add button does NOT save the changes permanently.
All unsaved changes are erased after you reboot the Switch.
15.4 Reboot System
Reboot System allows you to restart the Switch without physically turning the power off. It
also allows you to load the configuration file when you reboot. Follow the steps below to
reboot the Switch.
1 In the Maintenance screen, click the Config 1 button next to Reboot System to reboot
and load configuration one. The following screen displays.
Figure 46 Reboot System: Confirmation