ZyXEL Communications ES-315 - Manual (Page 53)

Chapter 6 Basic Setting
ES-315/ES-315-F User’s Guide
53
6.7 Port Setup
Use this screen to configure Switch port settings. Click Basic Setting and then Port Setup in
the navigation panel to display the configuration screen.
Figure 21 Basic Setting > Port Setup
The following table describes the labels in this screen.
Delete Check the management IP addresses that you want to remove in the Delete
column, then click the Delete button.
Cancel Click Cancel to clear the selected checkboxes in the Delete column.
Table 10 IP Setup (continued)
LABEL DESCRIPTION
Table 11 Basic Setting > Port Setup
LABEL DESCRIPTION
Port This is the port index number.
* Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this
row first to set the common settings and then make adjustments on a port-by-port
basis.
Note: Changes in this row are copied to all the ports as soon as you
make them.
Active Select this check box to enable a port. The factory default for all ports is enabled. A
port must be enabled for data transmission to occur.
Name Enter a descriptive name that identifies this port. You can enter up to 64 alpha-
numerical characters.
Note: Due to space limitation, the port name may be truncated in
some web configurator screens.
Type This field displays 10/100M for Ethernet connections.