ZyXEL Communications ES-315 - Manual (Page 103)

Chapter 16 Access Control
ES-315/ES-315-F User’s Guide
103
16.3.3 Configuring SNMP
From the Access Control screen, display the SNMP screen. You can click Access Control to
go back to the Access Control screen. Use this screen to configure your SNMP settings.
Figure 53 Access Control: SNMP
The following table describes the labels in this screen.
Table 35 SNMP Switch Traps
OPTION OBJECT LABEL OBJECT ID DESCRIPTION
rmon RmonRisingAlarm 1.3.6.1.2.1.16.0.1 This trap is sent when a variable
goes over the RMON "rising"
threshold.
RmonFallingAlarm 1.3.6.1.2.1.16.0.2 This trap is sent when the variable
falls below the RMON "falling"
threshold.
Table 36 Access Control: SNMP
LABEL DESCRIPTION
Get Community Enter the Get Community string, which is the password for the incoming Get- and
GetNext- requests from the management station.
The Get Community string is only used by SNMP managers using SNMP version
2c or lower.
Set Community Enter the Set Community, which is the password for incoming Set- requests from
the management station.
The Set Community string is only used by SNMP managers using SNMP version
2c or lower.
Trap Community Enter the Trap Community string, which is the password sent with each trap to
the SNMP manager.
The Trap Community string is only used by SNMP managers using SNMP
version 2c or lower.
Trap Destination Enter the IP addresses of up to four managers to send your SNMP traps to.