ZyXEL Communications Internet Security Appliance ZyWALL5UTM 4.0 - Manual (Page 616)

ZyWALL 5/35/70 Series User’s Guide
Chapter 47 Firmware and Configuration File Maintenance 616
47.4.2 Restore Using FTP Session Example
Figure 373 Restore Using FTP Session Example
ftp> put config.rom rom-0
200 Port command okay
150 Opening data connection for STOR rom-0
226 File received OK
221 Goodbye for writing flash
ftp: 16384 bytes sent in 0.06Seconds 273.07Kbytes/sec.
ftp>quit
Refer to Section 47.3.5 on page 611 to read about configurations that disallow TFTP and FTP
over WAN.
47.4.3 Restore Via Console Port
Restore configuration via console port by following the HyperTerminal procedure shown next.
Procedures using other serial communications programs should be similar.
1 Display menu 24.6 and enter “y” at the following screen.
Figure 374 System Maintenance: Restore Configuration
Ready to restore Configuration via Xmodem.
Do you want to continue (y/n):
2 The following screen indicates that the Xmodem download has started.
Figure 375 System Maintenance: Starting Xmodem Download Screen
Starting XMODEM download (CRC mode) ...CCCCCCCCC
3 Run the HyperTerminal program by clicking Transfer, then Send File as shown in the
following screen.
Figure 376 Restore Configuration Example
Type the configuration file’s location,
or click Browse to search for it.
Choose the Xmodem protocol.
Then click Send.