ZyXEL Communications Internet Security Appliance ZyWALL5UTM 4.0 - Manual (Page 613)

ZyWALL 5/35/70 Series User’s Guide
613 Chapter 47 Firmware and Configuration File Maintenance
47.3.8 GUI-based TFTP Clients
The following table describes some of the fields that you may see in GUI-based TFTP clients.
Table 232 General Commands for GUI-based TFTP Clients
COMMAND DESCRIPTION
Host Enter the IP address of the ZyWALL. 192.168.1.1 is the ZyWALL’s default IP
address when shipped.
Send/Fetch Use “Send” to upload the file to the ZyWALL and “Fetch” to back up the file on your
computer.
Local File Enter the path and name of the firmware file (*.bin extension) or configuration file
(*.rom extension) on your computer.
Remote File This is the filename on the ZyWALL. The filename for the firmware is “ras” and for
the configuration file, is “rom-0”.
Binary Transfer the file in binary mode.
Abort Stop transfer of the file.
Refer to Section 47.3.5 on page 611 to read about configurations that disallow TFTP and FTP
over WAN.
47.3.9 Backup Via Console Port
Back up configuration via console port by following the HyperTerminal procedure shown
next. Procedures using other serial communications programs should be similar.
1 Display menu 24.5 and enter “y” at the following screen.
Figure 368 System Maintenance: Backup Configuration
Ready to backup Configuration via Xmodem.
Do you want to continue (y/n):
2 The following screen indicates that the Xmodem download has started.
Figure 369 System Maintenance: Starting Xmodem Download Screen
You can enter ctrl-x to terminate operation any
time.
Starting XMODEM download...
3 Run the HyperTerminal program by clicking Transfer, then Receive File as shown in the
following screen.