Zoom Gateway/Router Zoom V3 - Manual (Page 22)

22 Zoom V3 User’s Guide
If you have changed the system settings on your V3 unit and for
some reason want to restore them to the factory default settings,
you can do so in one of two ways: You can perform a software
reset or a hard reset.
If you can open your Web browser and access your V3’s user
interface, here’s how to perform a software reset:
• From the Advanced Setup page, under Administration, click
Reset to Default. You will be prompted to click the Write
Settings to Flash and Reboot button. Once this process is
complete, your unit is reset to its factory settings. Click on any
of the icons at the top of the page to continue.
If you lose your link to the unit and cannot communicate with it
via the Web browser, here’s how to perform a hard reset.
• Using a paper clip, press the RESET button on the unit’s back
panel. While holding in this button, count to five, and then
release the button. You are now guaranteed that all system
settings are restored to the unit’s factory defaults.
1.8 Windows Users: Removing
the V3
If you have Windows and want to remove your V3—for instance,
if you move your computer to a location without broadband
service—you should remove the software before disconnecting the
hardware.
1111
From the desktop, select Start | Programs | Zoom VoIP
Gateway | Uninstall.
2222
When prompted to confirm your choice, click Yes
.
3333
When the process is complete, you will be prompted to
click Finish.
4444
Unplug your V3 hardware
.