Xerox Phaser 6110MFP - Manual (Page 6)

i
Safety Introduction
Notices and Safety
Please read the following instructions carefully before operating the machine
and refer to them as needed to ensure the continued safe operation of your
machine.
Your Xerox product and supplies have been designed and tested to meet
strict safety requirements. These include safety agency evaluation and
certification, and compliance with electromagnetic regulations and
established environmental standards.
The safety and environment testing and performance of this product have
been verified using Xerox materials only.
WARNING: Unauthorized alterations, which may include the addition of new
functions or connection of external devices, may impact the product
certification. Please contact your Xerox representative for more information.
Marks and Labels
Symbols
All warnings and instructions marked on or supplied with the product should
be followed.
WARNING: This symbol alerts users to areas of the equipment
where there is the possibility of personal injury.
WARNING: This symbol alerts users to areas of the equipment
where there are heated or hot surfaces, which should not be
touched.
CAUTION: This symbol alerts users to areas of the equipment
which require special attention to avoid the possibility of personal
injury or damage to the equipment.
WARNING: This symbol indicates a Laser is being used in the
equipment and alerts the user to refer to the appropriate safety
information.
TIP: This symbol identifies information that is being emphasized
and is important for you to remember.
Radio Frequency Emissions
FCC Notices For The USA
NOTE : This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications to this equipment not specifically approved by the
Xerox Corporation may void the user's authority to operate this equipment.
EME Compliance for Canada
This Class "B" digital apparatus complies with Canadian ICES-003.
Cet appareil num é rique de la classe "B" est conforme à la norme NMB-003
du Canada.
Laser Safety Information
Laser Safety
CAUTION: Use of controls, adjustments, or performance of
procedures other than those specified in this guide may result in
hazardous light exposure.
This equipment complies with international safety standards and is
classified as a Class 1 Laser Product.
With specific reference to lasers, the equipment complies with laser
product performance standards set by governmental, national, and
international agencies as a Class 1 Laser Product. It does not emit
hazardous light, as the beam is totally enclosed during all phases
of customer operation and maintenance.
Operational Safety Information
Operational Safety Information
Your Xerox equipment and supplies have been designed and tested to meet
strict safety requirements. These include safety agency examination,
approval, and compliance with established environmental standards.
To ensure the continued safe operation of your Xerox equipment, follow these
safety guidelines at all times:
Do These
• Always follow all warnings and instructions that are marked on or
supplied with the equipment.
• Before cleaning this product, unplug the product from the electrical
outlet. Always use materials specifically designated for this product,
the use of other materials may result in poor performance and create a
hazardous situation.