Zoom G2.1NU - Manual (Page 8)

8 ZOOM G2Nu/G2.1Nu
Select a Patch and Play (Play Mode)
1. Turn the power on
2. Set the unit to play mode
Minimize the volume of the amp.
When using an amp, turn its power on and raise its volume.
Turn the module selector to "PLAY."
Turn one of the parameter knobs (1–3) to open the following screen.
■ When using batteries
Turn the POWER switch ON.
■ When using an AC adapter
Connect the AC adapter, and turn the POWER switch ON.
HINT
Turn the POWER switch OFF and connect the USB connector to
a computer to operate the unit using bus power (→P29).
HINT
Immediately after turning the power ON, play mode is
activated regardless of the position of the module selector.
HINT
• If you do not save changed parameters (→ P22), all changes will be lost
when you select a different patch.
• When using headphones or a mixer, we recommend that you use the direct
mode (→ P24), which simulates the sound of a guitar cabinet.
• Adjust the volume for all patches using the master level (→P30).
Functions of
Parameter knobs 1–3
Current settings of
Parameter knobs 1–3
Patch name
Bank name/
patch number
DRIVE module tone
Patch volume
DRIVE module
distortion depth