Zoom G2.1NU - Manual (Page 14)

14
Using the Looper
ZOOM G2Nu/G2.1Nu
■ If a note mark was chosen
Recording continues for the set time and then loop
playback starts (and "PLAY" appears on the display).
■ If "Manual" was chosen
When the [▲] foot switch is pressed again, or the
maximum time (about 5 seconds) is reached, loop
playback starts (and "PLAY" appears on the display).
4. Record a phrase and play it back
Press the [▲] foot switch, and play the phrase that you want to record.
"REC" appears on the display and recording starts.
Depending on the recording method chosen in step 2, recording occurs as follows.
"REC" appears on the display and overdubbing starts.
When the end of the recorded phrase is reached, playback returns to the loop beginning and overdubbing continues.
Loop playback
Playback
Recording
[▲] foot switch
[▲]
foot
switch
Set time
Loop playback
Playback
Recording
[▲] foot switch
5. Overdub a phrase
During loop playback, press the [▲] foot switch.
HINT
When using the looper, the unit can also play a rhythm (→P16). However, the
parameter knobs only control the looper.