Zoom G2.1NU - Manual (Page 46)

46
Effect Types and Parameters
ZOOM G2Nu/G2.1Nu
ModDelay (modulation delay)
This delay effect allows the use of modulation.
PARM1 PARM2 PARM3
Time
1–2000 mS
F.B (feedback) 0–100 Mix 0–100
Sets the delay time. Adjusts the feedback amount.
Higher values cause more delay
sound repetitions.
Adjusts the amount of effected
sound that is mixed with the
original sound.
DynaDelay (dynamic delay)
This dynamic delay adjusts the volume of the effect sound according to the input signal level.
PARM1 PARM2 PARM3
Time
1–2000 mS
Sense (sensitivity) ±10 Mix 0–100
Sets the delay time. Adjusts the effect sensitivity. As
the input becomes louder, the
effect sound increases with
positive values and decreases
with negative values.
Adjusts the amount of effected
sound that is mixed with the
original sound.
DELAY module
This delay module allows the use of a hold function.
Delay
This long delay has a maximum length of 5000 mS.
Echo
This tape echo simulation has a long delay with a maximum length of 5000 mS.
AnalogDLY (analog delay)
This analog delay simulation has a long delay with a maximum length of 5000 mS.
PingPongD (ping-pong delay)
This ping-pong delay outputs the delay sound alternately to the left and right.
The four effect types above have the same parameters.
PARM1 PARM2 PARM3
Time
1–5000 mS
F.B (feedback) 0–100 Mix 0–100
Sets the delay time. Adjusts the feedback amount. Adjusts the amount of effected
sound that is mixed with the
original sound.