3 restore configuration, 1 restore using ftp – ZyXEL Communications ADSL2+ Ethernet/USB Gateway 660RU-Tx Series User Manual
Page 212

Prestige 660RU-Tx Series User’s Guide
211
Chapter 25 Firmware and Configuration File Maintenance
Refer to
the TFTP and FTP over WAN Management Limitations section
to read about
configurations that disallow TFTP and FTP over WAN.
25.3 Restore Configuration
This section shows you how to restore a previously saved configuration. Note that this
function erases the current configuration before restoring a previous back up configuration;
please do not attempt to restore unless you have a backup configuration file stored on disk.
FTP is the preferred method for restoring your current computer configuration to your Prestige
since FTP is faster. Please note that you must wait for the system to automatically restart after
the file transfer is complete.
25.3.1 Restore Using FTP
For details about backup using (T)FTP please refer to earlier sections on FTP and TFTP file
upload in this chapter.
Table 67 General Commands for GUI-based TFTP Clients
COMMAND DESCRIPTION
Host
Enter the IP address of the Prestige. 192.168.1.1 is the Prestige’s default IP address
when shipped.
Send/Fetch
Use “Send” to upload the file to the Prestige and “Fetch” to back up the file on your
computer.
Local File
Enter the path and name of the firmware file (*.bin extension) or configuration file (*.rom
extension) on your computer.
Remote File This is the filename on the Prestige. The filename for the firmware is “ras” and for the
configuration file, is “rom-0”.
Binary
Transfer the file in binary mode.
Abort
Stop transfer of the file.
Note: Do not interrupt the file transfer process as this may
permanently damage your Prestige.