ZyXEL Communications XGS-4528F User Manual
Page 57
Chapter 4 The Web Configurator
XGS-4528F User’s Guide
57
Auth and Acct
This link takes you to screens where you can configure authentication and
accounting services via external servers. The external servers can be either
RADIUS (Remote Authentication Dial-In User Service) or TACACS+ (Terminal
Access Controller Access-Control System Plus).
IP Source Guard This link takes you to screens where you can configure filtering of unauthorized
DHCP and ARP packets in your network.
Loop Guard
This link takes you to a screen where you can configure protection against network
loops that occur on the edge of your network.
IP Application
Static Route
This link takes you to a screen where you can configure static routes. A static route
defines how the Switch should forward traffic by configuring the TCP/IP parameters
manually.
RIP
This link takes you to a screen where you can configure the RIP (Routing
Information Protocol) direction and versions.
OSPF
This link takes you to screens where you can view the OSPF status and configure
OSPF settings.
IGMP
This link takes you to a screen where you can configure the IGMP settings.
DVMRP
This link takes you to a screen where you can configure the DVMRP (Distance
Vector Multicast Routing Protocol) settings.
DiffServ
This link takes you to screens where you can enable DiffServ, configure marking
rules and set DSCP-to-IEEE802.1p mappings.
DHCP
This link takes you to screens where you can configure the DHCP settings.
VRRP
This link takes you to screens where you can configure redundant virtual router for
your network.
Management
Maintenance
This link takes you to screens where you can perform firmware and configuration
file maintenance as well as reboot the system.
Access Control
This link takes you to screens where you can change the system login password
and configure SNMP and remote management.
Diagnostic
This link takes you to screens where you can view system logs and can test port(s).
Syslog
This link takes you to screens where you can setup system logs and a system log
server.
Cluster
Management
This link takes you to a screen where you can configure clustering management
and view its status.
MAC Table
This link takes you to a screen where you can view the MAC address and VLAN ID
of a device attach to a port. You can also view what kind of device it is.
IP Table
This link takes you to a screen where you can view the IP addresses and VLAN ID
of a device attached to a port.You can also view what kind of device it is.
ARP Table
This link takes you to a screen where you can view the MAC address – IP address
resolution table.
Routing Table
This link takes you to a screen where you can view the routing table.
Configure Clone
This link takes you to a screen where you can copy attributes of one port to
(an)other port(s).
Table 6 Navigation Panel Links (continued)
LINK
DESCRIPTION