ZyXEL Communications XGS-4528F - Manual (Page 188)

Chapter 23 Authentication & Accounting
XGS-4528F User’s Guide
188
23.1.2 RADIUS and TACACS+
RADIUS and TACACS+ are security protocols used to authenticate users by means of an
external server instead of (or in addition to) an internal device user database that is limited to
the memory capacity of the device. In essence, RADIUS and TACACS+ authentication both
allow you to validate an unlimited number of users from a central location.
The following table describes some key differences between RADIUS and TACACS+.
23.2 Authentication and Accounting Screens
To enable authentication, accounting or both on the Switch. First, configure your
authentication server settings (RADIUS, TACACS+ or both) and then set up the
authentication priority and accounting settings.
Click Advanced Application > Auth and Acct in the navigation panel to display the screen
as shown.
Figure 94 Advanced Application > Auth and Acct
23.2.1 RADIUS Server Setup
Use this screen to configure your RADIUS server settings. See Section 23.1.2 on page 188 for
more information on RADIUS servers. Click on the RADIUS Server Setup link in the
Authentication and Accounting screen to view the screen as shown.
Table 61 RADIUS vs TACACS+
RADIUS TACACS+
Transport
Protocol
UDP (User Datagram Protocol) TCP (Transmission Control Protocol)
Encryption Encrypts the password sent for
authentication.
All communication between the client (the
Switch) and the TACACS server is
encrypted.