Fcc statement (u.s.a.) – Xerox 8160 User Manual

Page 2

Introduction Printer Options Menu Tree Technical Info Error Messages Troubleshooting

Reference Guide 8142/8160

The United States Federal Communications Commission has specified that the following notice be brought to the attention of users of
Xerox printers.

FEDERAL COMMUNICATIONS COMMISSION RADIO AND TELEVISION INTERFERENCE FOR CLASS A DEVICE

Statement

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications.

User Instructions:

If the equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment on
and off, the user is encouraged to try to correct the interference by one of the following measures:

•

Reorient or relocate the receiving antenna.

•

Increase the separation between the equipment and receiver.

•

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•

Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by

Xerox

could void the user’s authority to operate the equipment.

Note: This product was FCC certified under test conditions that included the use of shielded I/O cables and connectors between
system components. To be in compliance with FCC regulations, the user must use shielded cables and connectors and install them
properly.

FCC Statement (U.S.A.)