Xerox 8160 - Manual (Page 15)

Introduction Printer Options Menu Tree Technical Info Error Messages Troublesho
Introduction 1-10
Introduction 1
Introduction Printer Options Menu Tree Technical Info Error Messages Troubleshooting
Reference Guide 8142/8160
Basic and Microbanding Calibration Procedures
Before you start
The calibration procedures in this document are useful for 8142/8160 printers with firmware level 1.5.0 and later.
Confirm that you have at least that firmware level before you begin.
Checking firmware level
1 At the Control Panel select Utility/Service Menu/About.
2 Check for version 1.5.0 of the firmware (first line in display).
3 If the firmware version is:
· at least version 1.5.0 – proceed with calibration.
· prior to version 1.5.0 – update the firmware in the printer before you using these procedures.
Calibration Flowcharts
· For general calibration – use flowchart in Figure 1.
· After removing/installing a print cartridge – use flowchart in Figure 2.