Wegener Communications 6420 - Manual (Page 35)

iPump 6420 User’s Manual
www.wegener.com 800070-01 Rev B Chapter 2, Page 31
Connector
Designation
(Options shown
in
red )
Type Pin # Signal Description
USB USB type A jack Universal Serial Bus host-end
115/230 VAC Std IEC receptacle AC Line In
On Front-Panel
USB USB type A jack Universal Serial Bus host-end
2.4. Establishing Compel Network Control
After racking and cabling your iPump6420, it is now time to bring it up on the satellite
carrier (if applicable) or get it connected to the internet (if applicable), such that full Compel
network control may be implemented. This will allow your iPump 6420 to fully participate in
the rich feature set of WEGENER’s MediaPlan-based Store/Forward system.
In many cases, your unit was already pre-set at the factory per the instructions from your
network provider, and require no setup operations by the local user. In that case, see Section 2.5
Unit Indications, to confirm unit operation. If, however, your unit is not fully configured for
your site, then continue reading.
To start, check with your network operator to find out how your iPump6420 will be
controlled. Typical satellite networks require network control over the satellite channel.
However, special Microcasting sites will pull their network control commands and media file
downloads solely over the internet. After you have decided how you need to get network
control, then you need to configure, or check configuration of your i6420 unit. If you are going
to use local web control, then you are going to need to network a working computer, with
approved web browser (See Specifications, Chapter 1) to your i6420, and then, from the Front-
Panel, set the i6420’s LAN IP address. Subsection 2.4.1 covers this issue.
If you are not using web control to setup the i6420, but need to do some configuration
through the Front-Panel user interface, then see subsection 2.4.2.