Vertex Standard FT-1000MP - Manual (Page 28)

Page 26 O
PERATING
M
ANUAL
VFO & Memory Control
[A u B] Button:
Pressing this button for ½ second (until the double
beep) transfers data from the main display (either Main
VFO-A or a recalled memory channel) to Sub VFO-B,
overwriting any previous contents in the Sub VFO. Use
this key to set both Main and Sub Receivers to the
same frequency and mode.
[A u
t B] Button:
Pressing this button momentarily exchanges the
contents of Main VFO-A (or a recalled memory chan-
nel), and Sub VFO-B. No data is lost.
[M GRP] Button:
When more than one memory group has been en-
abled, pressing this button limits selection and scan-
ning to those memories within the selected group.
[M CK] (Memory Check) Button:
This key displays the contents of memory chan-
nels without disturbing operation. When pressed, “M
CK” is displayed above the channel number, and each
memory channel can then be checked on the Sub
Receiver display by rotating the VRF/MEM CH selec-
tor. Empty memory channels display as two decimals,
with no frequency digits. Press this button again to
cancel memory checking.
[A u M] Button:
Pressing and holding in this key for ½ second (un-
til the double beep) copies the current operating data
from Main VFO-A, or a recalled memory, to the cur-
rently selected memory channel, overwriting any pre-
vious data stored there. Also, pressing and holding this
button after recalling a memory, without first retuning,
causes the memory channel to be “masked,” and re-
peating the process restores the masked memory.
[RPT] Button:
For 29 MHz FM operation, this button activates the
standard HF FM repeater offset. Pressing [RPT] once
or twice while receiving causes the transmit frequency
to be shifted 100 kHz below or above the receiving
frequency, respectively. A selectable CTCSS
subaudible tone is also transmitted automatically when
using this feature, to allow access to repeaters that
require it. Pressing [RPT] a third time cancels repeater
shift operation.
SUB VFO-B [RX & TX Switch-LED]
These lamps select and indicate the current status
of Sub VFO-B. When the green “RX” lamp is lit, the
receiving frequency is under control of SUB VFO-B.
When the red “TX” lamp is lit, the transmitting frequency
is under control of SUB VFO-B. During dual receive
operation, the green “RX” lamps above both tuning
knobs Main and Sub) will be illuminated.
F
RONT
P
ANEL
C
ONTROLS
R X MAIN VFO-A
SUB VFO-B R X TX
NOTCH
TX
RCL 7
3
QMB BAND
STO
DUAL
M A
A B
M CK A M
M GRP
RPT
A B VFO/
MEM
FAST LOCK
LOCK
LSB
USB
CW
AM
FM
PKT
CLASS-A AF REV SPOT BK-IN KEYER SUB SQL SPEED
TUNER
NOR
SHIFT
NOTCH
WIDTH
CLAR
NAR1 NAR2
BAND WIDTH
NB
VRF
VRF/MEM CH
PITCH CLAR
CLEAR RX TX
1.8
1
1 0
4
2 1
7
SUB
DE
3.5
2
14
5
24.5
8
29
0
1 8
6
2 8
9
ENT
DOWN U P
DWN UP
IDBT
VRF IDBT