USRobotics U.S. Robotics SureConnect ADSL Ethernet/USB Router - Manual (Page 191)

U.S. Robotics SureConnect ADSL Ethernet/USB Router User Guide
Sets up a PPPoA profile.
Profile Profile number to configure. Specify an integer number from 0 through 7.
-if Interface name with unit number. Eight PPP interfaces are available: ppp0, ppp1,
ppp2, ppp3, ppp4, ppp5, ppp6, and ppp7.
-encap Encapsulation type. Possible values are LLC or VC.
-restarttime Timeout in milliseconds. The default is 3 seconds (3000 milli seconds).
-auth Authentication type (PAP or CHAP).
-myaddr Desired self IP Address (eg 192.168.26.7). Expressed in dot notation.
-peer Peer IP Address to optionally specify the IP address of the Internet Service
Provider. Expressed in dot notation.
-mtu Maximum Transmission Unit expressed in bytes. The default is 1500.
-mru Maximum Receive Unit, negotiated in LCP. The default is 1500.
-user Username.
-pass Password.
-vpi The ATM vpi value which was assigned in a vcadd command or listed in a
atmshowconn command.
-vci The ATM vci value which was assigned in a vcadd command or listed in a
atmshowconn command.
-nat enable|disable
Enables or disables NAT (Network Address Translation) for this PPP interface. The default is for
NAT to be disabled.
-netmask Specifies the netmask for the PPP interface. The mask is specified in dot
notation (i.e. 255.255.255.0).
-vpn Specifies the VPN encapsulation. The OUI (Organizationally Unique
Identifier) and VPN identifier are specified as numbers.
Example:
pppoa 1 –o -if ppp0 -vpi 0 -vci 100 -user jones -pass Indiana
Defines a PPPoA profile. The ppp0 interface is used with the ATM connection with vpi 0
and vci 100. The user name is “jones” and the password is “Indiana”.
file:///P|/T_WRITER/Documentation/Released/9003%20(Guinness)/User%20Guide/9003%20(Guiness)%20prac%20template/cli.htm (67 of 71) [11/6/2002 8:58:46 AM]