USRobotics U.S. Robotics SureConnect ADSL Ethernet/USB Router - Manual (Page 185)

U.S. Robotics SureConnect ADSL Ethernet/USB Router User Guide
< vpi > vpi number
< service > cbr / rtvbr / nrtvbr / ubr
Peak cell rate (in cells/s)
Average/minimum (SCR) cell rate (in cells/s)
Burst size in cells
Cell delay variation tolerance (in micro secs)
1.25 sndcp
The following commands are available under the “sndcp” directory.
1.25.1 routedbridge
routedbridge disable
routedbridge enable -o <-enc encapsulation> <-vpn OUI
vpnId>
Configures the specified WAN interface to use Routed Bridge which is RFC 2684 routing.
Note: The Maximum Transfer Unit (MTU) for the Routed Bridge is 9182.
Interface The name of the WAN interface. Typically this is ‘atm0’.
Enable Enables this Routed Bridge interface.
Disable Disables this Routed Bridge interface.
These are the vpi, vci values on which the Routed Bridge has to be enabled/disabled.
vpi,vci are assigned with the vcadd command. The showatmconn command can also be used to
list the current ATM connections with their respective vpi and vci values. (Note the vcadd and
showatmconn commands are located in the “atm” directory).
file:///P|/T_WRITER/Documentation/Released/9003%20(Guinness)/User%20Guide/9003%20(Guiness)%20prac%20template/cli.htm (61 of 71) [11/6/2002 8:58:46 AM]