Uniden DECT1915 - Manual (Page 52)

“There is inter-
ference and
noise on the
line.”
Move the handset closer to the base unit, or to a
different position.
Try moving the base unit so that it’s not near other
electrical equipment, such as a television or a
computer.
You’ll get the best results if you site the base unit as
high as possible. For example, in a two-storey house,
the first-floor landing is an ideal place for the base unit.
“I hear ‘beeps’
from my
handset while
I’m on a call.”
You may be going out of range of the base unit. Move
closer, or your call may be cut off.
Check the Battery Level symbol on the display. If it’s
low, recharge the batteries.
“The handset’s
display shows
No Base Found ”
Check that the base unit’s mains power adapter is
plugged in and power is switched on.
Move the handset closer to the base unit.
If you have a new handset, not supplied as part of your
original DECT 1915/1915+1 system, you need to register it
to the base unit (see page 28).
If the batteries have become completely run down (or if
the handset is switched off) and you place the handset
in the charging cradle, it may take about 5 minutes to
link with the base station. Wait and try again.
“The Caller
Display feature
isn’t working.”
You need to subscribe to the Caller Display feature
from your network service provider. You should
find contact details on your phone bill.
The caller may have withheld their number .
Or they may be calling from a network that does
not transmit the caller’s number (for example, it may be
an international call).
Troubleshooting
49