Uniden DECT1915 - Manual (Page 31)

Handset registration
! You don’t need to register any handsets which were
supplied as part of the system with your base unit —
they are already registered. But if you’ve bought any
extra handsets separately, you’ll need to register them.
To check whether a handset is already registered, make
sure mains power to the base unit is switched on
and the handset is within range. The handset’s display
should show its name (default
) and number.
If the display constantly shows No base found , you
need to register the handset.
Each handset can be registered to up to four base
units, which have numbers 1 to 4.
To re-register
or to register a
new handset 1 On the base unit, press and hold the
HANDSET LOCATOR button until you hear
Registration tone (repeated ‘beeps’)
You now have 60 seconds to register the
handset.
2 On the handset, press the right Soft button
[
Menu ], then press the ‡ or ˆ button to
scroll to Handset
3 Press the right Soft button [ OK ]
4 Press the
‡
or
ˆ
button to scroll to Register,
then press the right Soft button [ OK ]
u The display shows a list of base units. If any
of these numbers has a tick next to it, the
handset is already registered to that base unit.
5 Move the highlight to BASE: 1 then press the
right Soft button [ OK ]
u The display shows Base-PIN:
6 Key in the base unit’s PIN code (default 0000)
If the base unit’s PIN code has been changed
from 0000 (see page 44), you’ll need to know
the current PIN code.
28
Handset