Uniden DECT2080 - Manual (Page 50)

49
Resetting the Handset Without the Base
If.your.original.base.is.not.available.for.some.reason,.you.can.still.reset.the.handset.and.use.it.with.another.base.
Press.and.hold.[ ].and.[#] for at least five seconds.
Move.the.cursor.to.select.BASEUNAVAILABLE.and.then.press.[Menu/Select]..BASE.UNAVAILABLE.appears.
Select.the.base.which.you.want.to.de-register.from,.and.then.press.[Menu/Select].
Move.the.cursor.to.select.YES,.and.then.press.[Menu/Select]. You hear a confirmation tone, and the handset
deletes.its.own.base.information.without.contacting.the.base..If.the.handset.was.registered.to.only.one.base,.it.
displays.HANDSET.NOT.REGISTERED-PLACE.HANDSET.ON.BASE.TO.REGISTER..SEE.YOUR.OWNER'S.
MANUAL.FOR.HELP..If.the.handset.is.still.registered.to.another.base,.it.searches.for.the.other.base.and.then.
returns.to.standby.
Register.the.handset.to.the.new.base.(see.Registering.Accessory.Handsets.on.page.20).
Traveling Out of Range
During.a.call,.if.you.move.your.handset.too.far.from.your.base,.noise.may.increase..If.you.pass.the.range.limit.of.the.
base,.the.handset.will.beep,.display.OUT.OF.RANGE,.and.then.go.to.standby..The.base.will.maintain.the.connection.
for.thirty.seconds.after.the.handset.goes.out.of.range..If.you.move.the.handset.back.within.range.of.the.base.within.
thirty.seconds,.press.[ /Flash].or.[
]
.to.pick.up.the.call.again.
Note:. If.it.is.set.to.automatically.select.the.available.base,.the.handset.will.begin.searching.for.another.base.thirty.
seconds.after.going.out.of.range..(see.Selecting.the.Base.on.page.2).
)
2)
3)
4)
5)
UC536BV(DECT2080-2) OM.indb 49 3/24/2008 4:54:12 PM