Uniden DECT2080 - Manual (Page 42)

4
While.your.answering.system.is.set.to.“Announce.only,”.the.message counter.LED.on.the.base.displays.“A.”.If.you.
are.using.the.prerecorded.greeting,.the.system.automatically.switches.to.the.following.message:.“Hello,.no.one.is.
available.to.take.your.call..Please.call.again.”.If.you.are.using.a.personal.greeting,.the.system.continues.to.use.that.
greeting.
Activating the Message Alert
The message alert feature sounds a short alert tone every fifteen seconds whenever you have a new message.
To.turn.on.the.message.alert:
On.the.handset,.press.[Menu/Select]..Select.the.ANSW..SETUP.menu,.and.then.the.MESSAGE.ALERT.
submenu.
Move.the.cursor.to.select.ON.or.OFF.
Press.[Menu/Select]. You will hear a confirmation tone.
Activating Call Screening
Your.phone.allows.you.to.listen.to.callers.leaving.you.a.message..This.call.screen.feature.can.be.turned.on.or.off.
On.the.handset,.press.[Menu/Select]..Select.the.ANSW..SETUP.menu.and.then.the.CALL.SCREEN.submenu.
Move.the.cursor.to.select.ON.or.OFF.
Press.[Menu/Select]. You will hear a confirmation tone.
Setting a Security Code or
Personal Identification Number (PIN)
To.play.your.messages.from.a.remote.location,.you.will.need.to.enter.a.two-digit.security.code.or.Personal.
Identification Number (PIN). The default security code is 80.
On.the.handset,.press.[Menu/Select]..Select.the.ANSW..SETUP.menu,.and.then.the.SECURITY.CODE.
submenu.
Use.the.number.keypad.([0].through.[9]).to.enter.a.two-digit.security.code.(0-99).
Press.[Menu/Select]. You will hear a confirmation tone.
)
2)
3)
)
2)
3)
)
2)
3)
UC536BV(DECT2080-2) OM.indb 41 3/24/2008 4:54:08 PM