Uniden DECT2080 - Manual (Page 46)

45
Operating the Answering System While You Are Away from Home
You.can.access.your.answering.system.while.you.are.away.from.home.to.check,.play,.and.delete.messages,.or.turn.
your.answering.system.on.and.off.
Notes:
The.answering.system.will.only.playback.messages.for.four.minutes.and.then.it.returns.to.the.command.waiting.
mode..To.continue.playing.your.messages,.press.[0].then.[2] again within fifteen seconds.
If.you.enter.an.incorrect.security.code.three.times,.you.will.hear.a.beep.and.the.answering.system.will.return.to.
standby.
To.operate.from.a.remote.location,.use.any.touch-tone.telephone,.and.follow.these.steps:
Call.your.telephone.number.and.wait.for.the.system.to.answer..If.the.answering.system.is.off,.it.will.answer.after.
about.ten.rings.and.sounds.a.series.of.beeps.
During.the.greeting.or.the.beeps.(if.answering.system.is.off),.press.[0].and.enter.your.security.code/PIN.within.
two seconds (see Setting a Security Code or Personal Identification Number (PIN) on page.4).
The.answering.system.announces.the.current.time.and.the.number.of.messages.stored.in.memory..
You.hear.“To.play.incoming.messages,.press.zero-two..For.help,.press.one-zero”.followed.by.a.beep.
Enter a remote command from the chart below. You have fifteen seconds to enter the first command; after the
first command, you have two seconds to enter each command.
Remote Commands
Command Function Command Function Command Function
[0]
.then.[1] Repeat.a.message*
[0]
.then.[4] Delete.a.message
[0]
.then.[9] Answering.system.off
[0]
.then.[2] Play.incoming.messages [0].then.[5] Stop.operation
[1]
.then.[0] Help
[0]
.then.[3] Skip.a.message
[0]
.then.[6] Answering.system.on
*.If.you.press.[0].then.[1] in the first four seconds of a message, the system skips to the previous message..
If.you.press.[0].then.[1] after the first four seconds of a message, the system repeats the current message.
When you finish, you will hear intermittent beeps indicating that the system is in the command waiting mode.
Enter another command from the chart within fifteen seconds.
Hang.up.to.exit.the.system..The.answering.system.automatically.returns.to.its.normal.standby.setting.
•
•
)
2)
3)
4)
5)
6)
UC536BV(DECT2080-2) OM.indb 45 3/24/2008 4:54:10 PM