Uniden DECT2080 - Manual (Page 23)

22
With.the.phone.in.standby,.press.[Menu/Select]..Select.the.HANDSET.SETUP.menu,.and.then.the.SELECT.
BASE.submenu.
Move.the.cursor.to.select.the.base.you.want.to.connect.to,.or.choose.AUTO.to.have.the.handset.automatically.
select.the.base.
Press.[Menu/Select]..SEARCHING.will.appear.in.the.display.
When.the.base.is.found,.the.handset.will.return.to.standby..If.the.base.is.not.found,.“SEARCHING”.continues.
to appear. You can repeat the procedure listed above to return back to the original connection or to find the
different.base.
Note:. You.cannot.change.bases.during.a.call..
Setting Up the Phonebook
Your.handset.can.store.up.to.seventy.names.and.numbers.in.your.phonebook..When.all.the.phonebook.entries.are.
full,.you.will.hear.a.beep.and.MEMORY.FULL.appears..You.cannot.store.any.additional.names.and.numbers.unless.
you.delete.some.of.the.existing.ones.
You.can.also.use.the.phonebook.entries.to.store.a.group.of.numbers.(up.to.twenty.digits).that.you.may.need.to.enter.
once.your.call.connects..This.is.referred.to.as.chain.dialing..See.Chain.Dialing.from.the.Phonebook.on.page.29.
Creating Phonebook Entries
To.store.names.and.numbers.in.your.phonebook,.please.follow.these.steps:
When.the.phone.is.in.standby.mode,.press.[
]
.(on.the.left.side.of.the.four-
way.key).
To.create.a.new.phonebook.entry,.press.[Menu/Select]..Select.the.
CREATE.NEW.menu..EDIT.NAME.appears.
Enter the name for this entry (EDIT NAME).
.
Use.the.keypad.to.enter.a.name.for.this.entry;.the.name.can.contain.up.to.sixteen.characters..(See.Entering.
Text.from.Your.Handset.on.page..for.instructions.on.entering.text.).If.you.do.not.want.to.enter.a.name.for.this.
entry,.your.phone.will.store.this.entry.as...Press.[Menu/Select] when you are finished.
)
2)
3)
4)
)
2)
3)
E d i t N a m e
｡ E d i t N a m e
｡
UC536BV(DECT2080-2) OM.indb 22 3/24/2008 4:53:58 PM