beautypg.com

62hm15, Chapter 6: setting up your tv – Toshiba Integrated High Definition DLP 62HM15 User Manual

Page 42

background image

42

62HM15

Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.

Chapter 6: Setting up your TV

Manually adding and deleting channels
in the channel memory

After you have programmed the channels automatically, you can
manually add or delete individual channels in the channel
memory.

To add or delete channels in the channel memory:

1. Press MENU and open the SETUP menu.
2. Highlight INSTALLATION and press ENTER. (A new set

of INSTALLATION menu icons will appear on-screen, as
shown in step 3).

3. Open the TERRESTRIAL menu, highlight CHANNEL

ADD/DELETE, and then press ENTER.

Note: If you have a cable box connected to ANT 1 during
TV Guide On Screen

®

setup, the TERRESTRIAL menu will

not be accessible and you must then use the TV Guide
On Screen

®

channel editor to add/delete channels.

Terrestrial

Input Configuration
Channel program
Channel Add/Delete

Navigate

Select

Back

Exit

DVD RTN

CH RTN

EXIT

Signal Meter

4. The illustration below shows channels programmed for the

ANT 1 antenna input. To view the list of channels
programmed for the ANT 2 antenna input, highlight
CHANGE ANTENNA and press ENTER.

2

Analog

1

3

Analog

1

4

Analog

1

5

Analog

1

6

Analog

1

7

Analog

1

8

Analog

1

Channel

Signal

Antenna

Channel Add/Delete

Change Antenna

Clear All

Save

Cancel

Programming channels into the TV’s channel memory (continued)

To add a channel to the channel memory:

Highlight the unchecked box next to the channel number
you want to add, and then press ENTER to check the box.

To manually add digital subchannels on a physical channel:

Use the Channel Numbers and the Dash (–/100) on the
remote control to enter the channel number (for example,
56–1).
If the channel is found, the number will be added to the list
and the box will be checked.
If the channel is not found, a message will appear.

To remove a channel from the channel memory:

Highlight the checked box next to the channel number you
want to remove, and then press ENTER to uncheck the
box.

To save your new settings:

Highlight SAVE and press ENTER.

To revert to your original settings:

Highlight CANCEL and press ENTER before saving.

To remove all channels from the channel memory:

Highlight CLEAR ALL and press ENTER, and then
highlight SAVE and press ENTER.

Note:

• This action applies to the current antenna input only.

To delete/add channels on the other input, highlight
CHANGE ANTENNA and press ENTER.

• This action cannot be cancelled unless you highlight

CANCEL and press ENTER before saving your changes.

2

Analog

1

3

Analog

1

4

Analog

1

5

Analog

1

6

Analog

1

7

Analog

1

8

Analog

1

Channel

Signal

Antenna

Channel Add/Delete

Change Antenna

Clear All

Save

Cancel

#01E040-043_62HM15

5/24/05, 6:18 PM

42

Black