Programming channels automatically, 62hm15 – Toshiba Integrated High Definition DLP 62HM15 User Manual

Page 41

62HM15

Chapter 6: Setting up your TV

When you press CHANNEL

y or z on the remote control or

TV front panel, your TV will stop only on the channels stored
in the TV’s channel memory.
Follow the steps below to program channels into the TV’s
channel memory.

Programming channels automatically

Your TV can automatically detect all active channels in your
area and store them in its memory. After the channels are
programmed automatically, you can manually add or erase
individual channels.

Note:

• You must configure the antenna input sources before

programming channels (see page 40).

• The automatic channel programming process does NOT erase

channels that were previously programmed into the TV’s
memory, but adds newly found channels to the existing set of
programmed channels. To remove a channel from the memory,
you must manually delete it (see next page).

• To tune the TV to a channel not programmed in the channel

memory, you must use the Channel Number buttons on the
remote control.

• Programming channels for an antenna input configured for

CABLE will take substantially longer than for an antenna input
configured for ANTENNA. This is normal; however, once
channel programming is completed, you should not have to
repeat the programming process again unless your Cable TV
service lineup changes significantly.

• If you have a CableCARD™ inserted (page 12), channel

programming for ANT 1 is disabled because the CableCARD™
automatically loads the Cable channel list in the TV’s channel
memory.

To program channels automatically:

1. Make sure you have configured the antenna input sources.

See page 40 for details.

2. Press MENU and open the SETUP menu.
3. Highlight INSTALLATION and press ENTER. (A new set

of INSTALLATION menu icons will appear on-screen.

4. Open the TERRESTRIAL menu, highlight CHANNEL

PROGRAM, and press ENTER.

5. Highlight ANT 1 or ANT 2, depending on which antenna

input you want to program channels for, and then press
ENTER to start automatic channel programming.

Terrestrial

Input Configuration
Channel program
Channel Add/Delete

Navigate

Select

Back

Exit

DVD RTN

CH RTN

EXIT

Signal Meter

ANT 1

Antenna

39%

Scanning channels,please wait ...

Abort

The TV will automatically cycle through all the channels
for the antenna input you selected, and store all active
channels in the channel memory. While the TV is cycling
through the channels, the message “Scanning channels,
please wait” appears (as shown above right).
To cancel channel programming, either press EXIT or
highlight ABORT in the on-screen display and press
ENTER.

6. When channel programming is done, press

CHANNEL

y or z to view the programmed channels.

(Continued on next page)

Programming channels into the TV’s channel memory

ACTION

ENTER

MENU

–

100

+10

VOLUME

CHANNEL

EXIT

TV/VIDEO

POWER

CHANNEL

z / y

TV front touchpad

CHANNEL y

Channel
Numbers

(ENTER)

#01E040-043_62HM15

5/24/05, 6:18 PM

Black