Toshiba B-852-TS12-QP - Manual (Page 45)

APPENDIX 1 SPECIFICATIONS ENGLISH VERSION EO1-33028
A1.4 Ribbon
EA1- 5
A1.4 Ribbon
Please make sure that the ribbon being used is approved by TOSHIBA TEC. The warranty does not apply to any
problem caused by using non-approved ribbons.
For information regarding TOSHIBA TEC approved ribbon, please contact a sales representative.
Type Spool type
Width 120 – 220 mm
Recommended width is 120, 160 and 220 mm.
Length 300 m
Outside Diameter
φ
72 mm (max.)
The table below shows the correlation between ribbon width and media width (backing paper is not included).
Ribbon width Media width
120 mm 70 – 110 mm
160 mm 110 – 150 mm
220 mm 150 – 242 mm
NOTES:
1. To ensure print quality and print head life use only TOSHIBA TEC specified ribbons.
2. To avoid ribbon wrinkles use a ribbon that is wider than the media by 10 mm or more. However, too
much difference in width between the two may cause wrinkles.
3. Be sure to use 220 mm-wide ribbon when using 210 to 242 mm wide media.