Toshiba B-852-TS12-QP - Manual (Page 19)

2. PRINTER SETUP ENGLISH VERSION EO1-33028
2.7 Loading the Media
E2- 8
2.7.1 Installing the Media
onto the Supply Holder
Unit (Cont.)
The diagram below, and the steps that follow, show the procedures for
installing the Media onto the Supply Shaft and reassembling the Supply
Holder Unit. Be sure to follow the step-by-step procedure exactly or the
auto centering mechanism may not work properly.
Installing the Media and reassembling the Supply Holder
1.
Place the media roll onto the Supply Shaft with the media feeding
from the bottom as shown in the diagram above.
c
2. Align the tab of the Removable Supply Holder with the Slot in the
Supply Shaft, then reinstall the Removable Supply Holder by sliding it
onto the Supply Shaft as shown in the figure above.
3. Holding the reassembled Supply Holder Unit in your right hand, apply
pressure only to the reinstalled Removable Supply Holder to push it in
the direction of arrow
d
, causing the auto centering mechanism to
center the media on the Supply Shaft.
4. Tighten the green Supply Holder Locking Knob for the Removable
Supply Holder by turning it in the direction of arrow
e
.
5. Tighten the green Supply Holder Locking Knob for the Non-
removable Supply Holder by turning it in the direction of arrow
f
.
NOTES:
1. This Supply Holder accepts
four sizes of media core: 38
mm, 40 mm, 42 mm and
76.2 mm.. When using a
media roll of 38 mm, 40 mm,
or 42 mm, remove the
spacers from the Supply
Holders by pushing both
hooks of the Spacer. Keep
the removed Spacers safe.
2. Use only inside wound label
stock. Outside wound label
stock may not feed properly.
Use outside wound label
stock at your own risk.
3. Do not over-tighten the
green Supply Holder Locking
Knob.
If you turn the Removable
Supply Holder side down
after loading the media,
the media may drop by
weight. You might be
injured by the dropped
media.
WARNING!
CAUTION!
When installing the media
roll, do not push on the
Non-removable Supply
Holder as this will result in
the media roll not being
properly centred.
2
3
4
1
Non-removable
Supply Holder
Removable
Supply Holder
Green Supply
Holder Locking
Knob
Media Roll
Supply Shaft
Print Side
Slot Tab
1
1
2
Spacer
Supply Holder