Toshiba B-852-TS12-QP - Manual (Page 25)

2. PRINTER SETUP ENGLISH VERSION EO1-33028
2.10 Inserting the Optional PCMCIA Cards
E2-14
2.10 Inserting the
Optional PCMCIA
Cards
When the optional PCMCIA interface board is installed into the B-852
printer, there will be two PCMCIA slots available as shown in the figure
below. This allows for the use of Flash Memory Type Cards or I/O type
Cards such as LAN Cards. The following paragraphs outline how to
insert PCMCIA cards.
1. Make sure that the printer’s power switch is in the OFF position.
2. Hold the PCMCIA Card so that the model name printed side faces
right. Insert the card into the proper slot until the Eject Button pops
out.
3. The following PCMCIA cards can be used.
Type Maker Description Remarks
ATA Card
San Disk
Hitachi
A card conforming to
the PC card ATA
standard
----------
LAN Card 3 COM
Ether Link III
3C589D PC card
Install into the slot
(1) only. (This card
installed into the slot
(0) will not work.)
Flash
Memory
Card (4 MB)
Maxell ----------
CAUTION!
1. To protect PC cards,
discharge static
electricity from your body
by touching the metal
cabinet of the printer
before touching the card.
2. Before inserting or
removing a PCMCIA
card make sure that the
printer’s power is turned
off.
3. Be sure to protect
PCMCIA Cards when not
in use by putting them
into their protective
covers.
4. Do not subject the card
to any shocks or
excessive force nor
expose the card to
extremes in temperature
or humidity
5. The card may be
inserted into the slot
halfway even in the
wrong orientation.
However, the slot is
safety designed so that
the card will not be
connected to the
connector pins.
Slot 1:
(I/O type cards such as
LAN cards)
Slot 0:
(Memory type cards only)
Eject Button
Model Name Printed Side
CC EF-4M-TB
DC EF-4M-TB