Toshiba B-852-TS12-QP User Manual
Page 20
2. PRINTER SETUP
ENGLISH VERSION EO1-33028
2.7 Loading the Media
E2- 9
2.7.2 Installing the Supply
Holder Unit onto the
Supply Holder Frame
2.7.3 Loading Media into the
Printer
1.
Insert the assembled Supply Holder Unit into the rear notches of the
Supply Holder Frame as shown in the diagram below.
2.
Now feed the media from the bottom of the media roll into the media
slot at the rear of the printer as shown.
The following paragraphs outlines how to properly install the media into
the printer from the Supply Holder Unit that has been installed in the
previous steps.
1.
Raise the Top Cover as shown in the diagram below.
CAUTION!
The reassembled Supply
Holder Unit and media roll
may be quite heavy, so be
careful not to pinch your
fingers when installing the
Supply Holder Unit onto the
Supply Holder Frame.
Top Cover
NOTE:
Make sure that the brass
bushings of the Supply Shaft
are seated into the notches so
that the entire Supply Holder
Unit rotates smoothly.
Rear Notch
Supply Holder
Frame
Brass Bushing
Rear Notch