5 lock time, 4 clock generator registers, Section 1.4.4 – Texas Instruments TMS3320C5515 User Manual
Page 29
www.ti.com
System Clock Generator
shows programming examples for different PLL MODE frequencies.
Table 1-11. Examples of Selecting a PLL MODE Frequency, When CLK_SEL=L
RDBYPASS
OUTDIVEN
M
RDRATIO
ODRATIO
PLL Output Frequency
1
0
173h
X
X
32.768KHz x (173h+4) = 12.288 MHz
1
1
E4Ah
X
2
32.768KHz x (E4Ah + 4)/3 = 40.00 MHz
1
0
723h
X
X
32.768KHz x (723h + 4) = 60.00 MHz
1
0
8EDh
X
X
32.768KHz x (8EDh + 4) = 75.01 MHz
1
0
BE8h
X
X
32.768KHz x (BE7h + 4) = 100.01 MHz
1
0
E4Ah
X
X
32.768KHz x (E4Ah + 4) = 120.00 MHz
1.4.3.2.5 Lock Time
As previously discussed, you must place the clock generator in bypass mode before changing the PLL
settings. The time it takes the PLL to complete its phase-locking sequence is referred to as the lock time.
The PLL has a lock time of 4 ms. Software is responsible for ensuring the PLL remains in
BYPASS_MODE for at least 4 ms before switching to PLL_MODE.
1.4.3.2.6 Software Steps To Modify Multiplier and Divider Ratios
You can follow the steps below to program the PLL of the DSP clock generator. The recommendation is to
stop all peripheral operation before changing the PLL frequency, with the exception of the device CPU and
USB. The device CPU must be operational to program the PLL controller. Software is responsible for
ensuring the PLL remains in BYPASS_MODE for at least 4 ms before switching to PLL_MODE.
1. Make sure the clock generator is in BYPASS MODE by setting SYSCLKSEL = 0.
2. Set CLR_CNTL = 0 in CGCR1.
3. Program RDRATIO, M, and RDBYPASS in CGCR2 according to your required settings.
4. Program ODRATIO and OUTDIVEN in CGCR4 according to your required settings.
5. Write 0806h to the INIT field of CGCR3.
6. Set PLL_PWRDN = 0, CLR_CNTL = 1.
7. Wait 4 ms for the PLL to complete its phase-locking sequence.
8. Place the clock generator in its PLL MODE by setting SYSCLKSEL = 1.
1.4.4 Clock Generator Registers
lists the registers associated with the clock generator of the DSP. The clock generator
registers can be accessed by the CPU at the 16-bit addresses specified in
. Note that the CPU
accesses all peripheral registers through its I/O space. All other register addresses not listed in
should be considered as reserved locations and the register contents should not be modified.
Table 1-12. Clock Generator Registers
CPU Word
Acronym
Register Description
Section
Address
1C20h
CGCR1
Clock Generator Control Register 1
1C21h
CGCR2
Clock Generator Control Register 2
1C22h
CGCR3
Clock Generator Control Register 3
1C23h
CGCR4
Clock Generator Control Register 4
1C1Eh
CCR1
Clock Configuration Register 1
1C1Fh
CCR2
Clock Configuration Register 2
29
SPRUFX5A – October 2010 – Revised November 2010
System Control
Copyright © 2010, Texas Instruments Incorporated