Toshiba TOSVERT VF-S11 - Manual (Page 48)

E6581222
46
„ Communication command3
(Communication number: FA26)
The RY Terminal Output Hold Command and OUT Terminal Output Hold Command are always en-
abled even though communication command priority is not set.
Table 3 Data construction of Serial Communication Command 3 (FA26)
Bit Function 0 1 Remarks
0 RY terminal output hold OFF
Once it is turned
on, a RY terminal
holds that condi-
tion.
Always enabled even if
communication command
is not enabled
1 OUT terminal output hold OFF
Once it is turned
on, an OUT ter-
minal holds that
condition.
Always enabled even if
communication command
is not enabled
2 (Reserved)
3 (Reserved)
4 (Reserved)
5 (Reserved)
6 (Reserved)
7 (Reserved)
8 (Reserved)
9 (Reserved)
10 (Reserved)
11 (Reserved)
12 (Reserved)
13 (Reserved)
14 (Reserved)
15 (Reserved)
„
Frequency setting from the computer
(communication number: FA01)
Setting range: 0 to Maximum frequency ()
This frequency command is enabled only when the frequency command by communication is en-
abled by setting “serial communication (“3” for Communication Number FA04) by the speed com-
mand selection parameter () or setting command priority (Bit 14 of Communication Number
FA00 to “1” (enable)) by the communication command. In this case, frequency commands by
communication will be enabled independent of  setting. However, enabled commands and
frequencies are given the priority if “48: Forced change from communication to local,” “52: Forced
operation,” or “53: Fire speed” is set by input terminal function selection ( to ).
Once enabled, this frequency setting will be enabled till disable is set (0 setting), power is turned off
or is reset, or standard shipment setting () is selected.
Set a frequency by communication hexadecimal in Communication Number FA01. (1 = 0.01Hz
(unit))
Example: Operation frequency 80Hz command (PFA011F40) CR
80Hz = 80 ÷ 0.01 = 8000 = 1F40H