TANDBERG High Definition Professional Recevier/Decoder TT1280 - Manual (Page 39)

Operating the Equipment Locally
Reference Guide: TT128x High Definition Professional Receiver/Decoder Page 3-3
ST.RE.E10141.5
3.1 Powering the Equipment
3.1.1 Switching On
CAUTION...
This equipment should not be operated unless the cooling fan is working and there is free-air flow
around the unit.
Connect the signal inputs and ac power supply to the IRD and power up
the unit. After a short period of initialisation and the IRD gaining lock, the
unit powers up in Navigate mode. This is the usual operating condition.
The Lock LED will be on (green) when a signal is locked and off when
unlocked. See Figure 3.2 for the location of the Lock LED.
3.1.2 Power-up Operating Modes
No
IRD INITIALISING is displayed
during power-up. The Alarm LED
and Lock LED illuminate briefly
Yes
Secondary
Flash code
is loaded
Is the
RIGHT button
held in?
Power-up
Show SERVICE Menu (#3)
Initialisation
Local Remote
NCP
What was
Control Mode at
Power Off?
REMOTE
CONTROL
NCP Command
Enter PIN
Only available when
VideoGuard is
installed and a valid
Smart Card inserted
TANDBERG
DIRECTOR
NCP
CONTROL
LOCAL
LOCKOUT
(LOCAL)
CONTROL
FRONT
PANEL
Figure 3.1: Power-up Operating Mode