Lnb power and control, Table b.8 for qpsk bit-rate r188 limits, Table b.9 – TANDBERG High Definition Professional Recevier/Decoder TT1280 User Manual
Page 101
Technical Specification
Reference Guide: TT128x High Definition Professional Receiver/Decoder
Page B-9
ST.RE.E10141.5
Table B.8: QPSK Bit-rate R188 Limits (Mbit/s)
FEC R188min
R188max
1/2 1.000000 41.470588
2/3 1.228758 55.294118
3/4 1.382353 62.205882
5/6 1.535948 69.117647
7/8 1.612745 72.573529
LNB Power and Control
The IRD provides LNB power and control signals through the active RF
input connector. LNB power and controls are enabled through the Satellite
Input Menu, see Annex C, Menus.
The IRD supports voltage controlled LNBs only. The LNB power circuit
provides automatic protection against short circuits in the LNB or its cable.
When the short circuit has been removed recovery is automatic.
Switchable boost of the LNB voltage to allow for losses in long cables and
control of 22 kHz tone insertion are provided. The LNB power
characteristics are as per Table B.9.
Table B.9: LNB Power and Control
Parameter Specification
Voltage V (nominal)
Receiver Polarisation
5
Voltage 13
18
Vertical/circular right
Horizontal/circular left
Current
350 mA maximum
LNB control
22
± 2 kHz tone
Tone amplitude
0.6
±0.2 Vp-p
Boost voltage
1 V typical
5
Receive Polarisation: As specified in ETS 300 784: Satellite Earth Station and Systems (SES); Television Receive-only
(TVRO) earth stations operating in the 11/12 GHz frequency bands.