System menu (menu 7), Setup menu, C.9.1 – TANDBERG High Definition Professional Recevier/Decoder TT1280 User Manual
Page 135: C.9 system menu (menu 7), C.9.1 setup menu
Menus
Reference Guide: TT128x High Definition Professional Receiver/Decoder
Page C-19
ST.RE.E10141.5
C.9
System Menu (Menu 7)
C.9.1 Setup
Menu
The Setup submenu allows the user to edit the operating mode, LCD
contrast, serial remote protocol, IP address, subnet mask, service hunt
mode, and the customisation key.
Table C.30: Setup Menu
Display Title: Setup
Description
Date: XX/XX/XXXX
Time: YY:YY:YY
XX/XX/XXXX is the system date from the TDT
YY:YY:YY is the system time from the TDT
Operating Mode
XXXXXXXXXXXXX
XXXXXXXXXXXXX is editable:
FRONT PANEL
SERIAL REMOTE (not supported in software version 1.0.0)
NETWORK (SNMP)
LCD Contrast XXXXXX
XXXXXX is editable in the range:
LOW
MEDIUM
HIGH
Serial Remote Protocol
XXXXXXXXXXXXXXXXXXXXX
XXXXXXXXXXXXXXXXXXXXX is editable:
RS-232 TTV, RS-232 ALTEIA AT ADDR YYY, RS-485 ALTEIA AT ADDR YYY
where YYY is IRD address from 000 to 999.
IP Address
XXX.XXX.XXX.XXX
XXX.XXX.XXX.XXX is the editable IP address
Subnet Mask
XXX.XXX.XXX.XXX
XXX.XXX.XXX.XXX is the editable subnet mask
Gateway Address
XXX.XXX.XXX.XXX
XXX.XXX.XXX.XXX is the editable Gateway address
Syslog Address
XXX.XXX.XXX
XXX.XXX.XXX is the editable Syslog address.
Restore System Defaults
Restores system defaults.
Service Hunt Mode
XXXXXXXX
XXXXXXXX is the editable parameter for setting automatic service selection
(ENABLED, DISABLED)
SI Mode
XXX
XXX is the editable parameter for SI detection (AUTO, ATSC, DVB)
Customisation Key
XXXXXXXXXXXXXXXXXXXXXX
XXXXXXXXXXXXXXXXXXXXXX is the editable parameter for entering
customisation keys