Toshiba TDP-B1 - Manual (Page 36)

29
Troubleshooting
Problem: Nothing on projection screen
• Make sure that the power cord is properly connected to a fully func-
tional AC electrical outlet. Make sure that the power cord is also
properly connected to the projector.
• If the projector is plugged into a power strip, make sure the power
strip is turned on.
• Make sure you have removed the lens cap on the projection lens at
the front of the projector.
• Make sure the lamp is switched on.
• Make sure that the cables do not have any bent pins.
Problem: Color or text not being projected
• You might need to adjust the brightness up or down until the text is
visible. Refer to “Brightness” on page 19 for more information.
Problem: The screen resolution is not right
• Make sure the computer’s video card is set for a resolution of no
greater than 1024x768.
Problem: Image isn’t centered on the screen
• Move the projector to reposition the image.
• Reposition the image using the software. Refer to “Horizontal posi-
tion” on page 22 and “Vertical position” on page 22.
• Be sure the projector is at a 90 degree angle to the screen.
Problem: Only the start-up screen displays
• Verify that the cables are connected correctly. See page 7 through
page 8 for connection procedures.
• Verify that the proper input source is connected. See “Source (keypad
only) or Computer and Video (remote only)” on page 16.