Toshiba TDP-B1 - Manual (Page 25)

18
U s i n g t h e P r o j e c t o r
Using the On-Screen Menus
The projector has six drop-down menus that allow you to make image
adjustments and change a variety of settings. Most of these adjustments
aren’t available directly from the keypad.
NOTE: Some menu items may
be grayed out at certain times.
This indicates the item is not
applicable to your setup (for
example, video standards do not
apply to computer sources) or
the item is not enabled until
another selection is made (for
example, Manual Tracking is
not available until Auto Image is
turned off).
To open the on-screen menus, press the menu button on the keypad or
remote. This changes the volume, source, and standby buttons on the
keypad to menu navigation buttons. Press the corresponding buttons to
move the cursor up, down, left, or right, or use the disk mouse on the
remote. To select a menu, move the cursor left and right to highlight the
menu you want. The drop-down menu appears.
F IGURE 12
Keypad navigation buttons and drop-down menu
To change a menu setting, use the up and down navigation buttons on
the keypad or the disk mouse on the remote to move the cursor up and
down to the item you want to change (the selected item is highlighted),
then use the left and right navigation buttons to adjust a setting. Some
submenus, such as Brightness, consist of a slider bar you use to increase
or decrease a value; some submenus, such as Standby Time, consist of
options you scroll through to select the desired one. All changes are
saved when you close the menus.
To access another menu, use the up and down navigation buttons or the
disk mouse to move back to the top of the current menu, then use the left
and right navigation buttons to move to another menu.
use these buttons to navigate through
the menus