Toshiba TDP-B1 - Manual (Page 19)

12
S e t t i n g u p t h e P r o j e c t o r
Turning Off the Projector
If you want to turn off the projector for a short period of time, press the
standby button on the keypad or remote. This blanks the screen for fif-
teen minutes, but keeps the projector running. (You can change the
amount of time the projector stays in standby mode; see “Standby
Time” on page 23 for details.) After 15 minutes, the lamp goes out (the
projector keeps running). To exit standby mode, press the
standby but-
ton again. (It may take several seconds for the projection lamp to reach
full power and project the image again.)
NOTE: Lamp life will be
extended if you turn the lamp
off, then wait 1 minute while the
lamp cools before unplugging
the projector. The Lamp LED
will light green when the lamp
has cooled. See page 16 for
detalils on the Lamp LED.
To completely power off the projector, unplug it. If you want to turn the
lamp back on immediately, you must allow about a minute for the lamp
to cool. The lamp won’t light if it’s too hot.