Tektronix 220e - Manual (Page 32)

2 Getting Set Up
2-20 Phaser 220i and Phaser 220e Color Printers
Front panel at power-up
All indicators light briefly and immediately go out, except POWER and
READY
, which remain on for about 10 seconds. Then the READY indicator
blinks while the POWER indicator remains on and the self-tests are run.
When both POWER and READY are on steady (not blinking), the self-tests
are complete.
When a standard transfer roll is more than 75 percent used up, the front-panel
RIBBON
indicator lights, reminding you that it is time to order a new
transfer roll.
When you install the sample transfer roll supplied with the printer, the
RIBBON
indicator may light as soon as you install it, or after you make a
few prints. This is because the sample transfer roll contains a limited number
of prints.
For complete information on the front-panel indicator lights, refer to “Front
panel (Phaser 220i and Phaser 220e)” on page 7-6.
ERROR JAM RIBBON COVER READY POWER
8869-26
MEDIA