Tektronix 220e - Manual (Page 100)

7 Front and Rear Panels
7-4 Phaser 220i and Phaser 220e Color Printers
Rear panel DIP switches (Phaser 220i)
Phaser 220i rear panel DIP switches
Switch Function Settings
1 Reset/run Up: The printer resets and does not accept data
while the switch is in this position.
Down. The printer runs a self-test, then proceeds
to run normally. Leave the switch
down for normal
operation.
2, 3, and 4 Configuration page
Sample prints See the table, “Phaser 220i DIP Switches 2, 3, and
4” on page 7-5.
5 Start Job Up: The Sys/Start job on the hard disk does
not run.
Down: The Sys/Start job runs.
6 Unused
7 Baud Rate Up: Fixed. Sets the serial communication
parameters to 1200 baud, software flagging, and
ignore parity.
Down: Variable. Lets you change the serial
communication parameters. The factory setting is
9600 baud, software flagging, and ignore parity.
8 and 9 Color correction See the table, “Phaser 220i DIP Switches 8 and 9”
on page 7-5.