Programming channels automatically – Toshiba 27HL95 User Manual

Page 36

(E) 27HL95 *Web 213 : 276

Chapter 6: Setting up your TV

When you press CHANNEL

y or z on the remote control or

TV top panel, your TV will stop only on the channels stored in
the TV’s channel memory.
Follow the steps below to program channels into the TV’s
channel memory.

Programming channels automatically

Your TV can automatically detect all active channels in your area
and store them in its memory. After the channels are
programmed automatically, you can manually add or erase
individual channels.

Note:

• You must configure the antenna input sources before

programming channels (see page 35).

• If the input signal type is set to Cable for an antenna input, the

automatic channel programming process erases channels that
were previously programmed into the TV’s memory.

• If the input signal type is set to Antenna, the automatic channel

programming process does NOT erase channels that were
previously programmed into the TV’s memory, but adds newly
found channels to the existing set of programmed channels. To
remove a channel from the memory, you must manually delete it
(see next page).

• To tune the TV to a channel not programmed in the channel

memory, you must use the Channel Number buttons on the
remote control.

• Programming channels for an antenna input configured for

Cable will take substantially longer than for an antenna input
configured for Antenna. This is normal; however, once channel
programming is completed, you should not have to repeat the
programming process again unless your Cable TV service lineup
changes significantly.

• If you have a CableCARD™ inserted (page 12), channel

programming for ANT 1 is disabled because the CableCARD™
automatically loads the Cable channel list into the TV’s channel
memory.

To program channels automatically:

1. Make sure you have configured the antenna input sources.

See page 35 for details.

2. Press MENU and open the Setup menu.
3. Highlight Installation and press ENTER. (A new set of

Installation menu icons will appear on-screen.)

Navigate

Select

Exit

EXIT

Installation

Sleep Timer

On/Off Timer

PC Settings

Auto

PC Audio

HDMI Audio

Gray Level

Setup

Back

RTN

4. Open the Terrestrial menu, highlight Channel Program,

and press ENTER.

5. Highlight ANT 1 or

ANT 2, depending on
which antenna input
you want to program
channels for, and then
press ENTER to start
automatic channel
programming.

ANT 1 Antenna

Scanning channels, please wait ...

Abort

52%

The TV will automatically cycle through all the channels

for the antenna input you selected, and store all active
channels in the channel memory. While the TV is cycling
through the channels, the message “Scanning channels,
please wait” appears (as shown above).

6. To cancel channel programming, either press EXIT or

highlight Abort in the on-screen display and press ENTER.
When channel programming is done, press CHANNEL
y or z to view the programmed channels.

Programming channels into the TV’s channel memory

CHANNEL

z / y

TV top panel

Terrestrial

Input Configuration

Channel Program

Channel Add/Delete

Signal Meter

Navigate

Select

Exit

EXIT

ANT1

ANT2

Back

RTN

Channel
Numbers

CHANNEL

MENU
(ENTER)

#01E_035-037_27HL95

05.9.12, 15:36

Black