Toshiba 27HL95 - Manual (Page 20)

20
Chapter 2: Connecting your TV
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
(E) 27HL95 *Web 213 : 276
Connecting a digital audio system
The TV’s DIGITAL AUDIO OUT terminal outputs a Dolby
Digital
or 2-channel down-mixed PCM (pulse-code
modulation) signal for use with an external Dolby Digital
decoder or other external audio system with optical audio input.
You will need:
one optical audio cable (Use an optical audio cable that has
the larger “TosLink” connector and not the smaller “mini-
optical” connector.)
To control the audio:
Turn on the TV and the digital audio device.
Press MENU on the TV’s remote control and open the Audio
menu.
Highlight Audio Setup and press ENTER.
In the Optical Output Format field, select either Dolby Digital
or PCM, depending on your
device (see “Selecting the
optical audio output format”
on page 72).
Audio Setup
MTS Stereo
Language English
Reset Done
Optical Output Format Dolby Digital
TV lower back panel
Dolby Digital decoder or
other digital audio system
Note:
• Some audio systems may not be compatible with Dolby Digital bitstream
signals. Older audio systems that are not compatible with standard
optical out signals may not work properly, creating a high noise level that
may damage speakers or headphones. THIS DAMAGE IS NOT
COVERED BY YOUR WARRANTY.
• The DIGITAL AUDIO OUT terminal may not output some digital audio
sources because of copy restrictions.
• The DIGITAL AUDIO OUT terminal outputs signals only when receiving
digital broadcasts.
Audio Settings
Advanced Audio Settings
Audio Setup
Audio
LINE IN Optical
Audio IN L R
#01E_012-022_27HL95 05.9.12, 15:33 20
Black