Toshiba B-570 - Manual (Page 45)

6-14
EM18-33010A 6. DIAG. TEST OPERATION
■ Parameter Setting Mode Table
(Revision Date: Dec. 10 ‘99)
6.3 PARAMETER SETTING MODE
Mode Name
FEED ADJUST
CUT ADJUST
BACK FEED ADJ.
X ADJUST
TONE ADJUST
(Thermal transfer printing)
TONE ADJUST
(Thermal direct printing)
FONT CODE
ZERO FONT
CODE
RIBBON
RIBBON ADJ
(Ribbon feed motor)
RIBBON ADJ
(Ribbon feed motor)
STATUS TYPE
STACKER SYSTEM
THRESHOLD R
THRESHOLD T
KANJI CODE
EURO CODE
DTR/RTS
INPUT PRIME
Function
Using this parameter the feed length is fine adjusted.
Using this parameter the cut position or strip position is fine adjusted.
Using this parameter the back feed length from the cut/strip position to the
home position is fine adjusted.
This setting is used to finely adjust print position in the X axis.
Using this parameter the print tone is fine adjusted. The longer the print
pulse width, the darker the print tone becomes. The shorter, the lighter
the print tone becomes.
The character code either PC-850 or PC-8 is selected.
The font zero either 0 or ø is selected.
The command code out of AUTO, ESC/LF/NUL, or { } is selected.
Ribbon type either transmissive or non-transmissive is selected.
Using this parameter the torque of the ribbon motors is fine adjusted.
Whether or not the strip wait status (05H) is sent in response to the status
request command from the PC is selectable.
Use of the Stacker is selected.
(not supported by QQ/QP models.)
The threshold of the black mark sensor is manually fine adjusted.
The threshold of the feed gap sensor is manually fine adjusted.
Kanji code either Windows code or original code is selected.
(not supported by QQ/QP models.)
EURO code is selected from 20H to FFH.
Transmission Control mode is selected from DTR and RTS.
Reset ON/OFF when the INPUT • PRIME signal on is selcted.