Toshiba B-570 - Manual (Page 36)

6-5
EM18-33010A 6. DIAG. TEST OPERATION
(Revision Date: Dec. 10 ‘99)
6.2 SELF TEST MODE
2) Parameters
#
(11)
(12)
(13)
(14)
(19)
(15)
(20)
(16)
(21)
(17)
(22)
(18)
(23)
(24)
(25)
(26)
(27)
(28)
(29)
(30)
(31)
(32)
(33)
Item
Character code selection
Font zero selection
Control code selection
Ribbon type selection
Feed length fine adjustment
(PC), (KEY)
Cut/strip position fine adjustment
(PC), (KEY)
Back feed length fine adjustment
(PC), (KEY)
Print tone fine adjustment
(Thermal transfer) (PC), (KEY)
Print tone fine adjustment
(Thermal direct) (PC), (KEY)
X axis fine adjustment
Ribbon Motor
Strip wait status
Threshold manual fine
adjustment for the black mark
sensor
Threshold manual fine
adjustment for the feed gap
sensor
Kanji code type
(not supported by QQ/QP
models.)
Euro font code setting
Stacker
(not supported by QQ/QP
models.)
Transmission Control Mode
Reset selection when the
INPUT • PRIME signal is ON.
Contents
PC-850 : PC-850
PC-8 : PC-8
0 : No slash used.
Ø : Slash used.
AUTO : Automatic selection
ESC LF NUL : ESC LF NUL mode
{ } : Mainframe mode
1B 1C 1D : Manual mode
TRANS. : Transmissive ribbon
NON TRANS. : Non-transmissive ribbon
-50.0 mm to +50.0 mm
-50.0 mm to +50.0 mm
-9.9 mm to +9.9 mm
-10 step to +10 step
-10 step to +10 step
-99.5 mm to +99.5 mm
+15 step to +0 step
1: Strip wait status is not sent to the PC.
2: Strip wait status is sent to the PC.
0.0 V to 4.0 V
0.0V to 4.0 V
TYPE 1: Windows code
TYPE 2: Original code
20H to FFH
OFF: No stacker
ON: with stacker
DTR: READY/BUSY (DTR) protocol (DTR/DSR)
RTS: READY/BUSY (RTS) protocol (RTS/CTS)
ON: The printer will restore to the initial status.
OFF: The printer will not restore to the initial status.