TRENDnet TE100-MP1U User Manual
Page 88
88
1. Plug in the power adaptor while pressing the Init button until LED indicators of
Power, USB1 and USB2 blink. (For TRENDnet 301, only USB1 LED will blink.)
Please note that after that, the Server will operate using the factory
default values after restarting, i.e., your Server’s configuration will
recover to Factory Default values.
2. Start the TFTP client Tool: Image Burner
3. Click Open Image to open your new firmware. Please note that you must
configure your PC’s TCP/IP such that PC and the Server belong to the same LAN,
i.e. PC’s IP is 192.168.1.xxx and subnet mask is 255.255.255.0.
4. Click Upload Image.
5. Wait for Image Uploading to finish and then click Close.
6. Plug-off the power adapter and then plug-in the power adapter to restart the
Server.