TRENDnet TE100-MP1U - Manual (Page 16)

16
8. Click Submit to save your settings. And the server will reboot.
9. You have now finished the procedure of setting the wireless parameters.
#
In infrastructure mode, TEW-MP2U searches all channels to join the matched wireless
service set. In ad-hoc mode, TEW-MP2U searches all channels to join the matched
wireless ad-hoc service set too, however, if none are found, TEW-MP2U creates that
service set in the assigned channel.
#
In ad-hoc mode, WPA-PSK/TKIP is not allowed.
After properly configuring the wireless parameters, you can remove the network
cable and reboot the TEW-MP2U . TEW-MP2U will then connect to your wireless network.
TEW-MP2U will detect if a network cable is plugged-in or not. If a network cable is
plugged-in,
TEW-MP2U will always connect to the network through the network cable.
Otherwise it will always connect to the network through wireless module. Once
TEW-MP2U connects to the network, either by network cable or by wireless module,
all operations of print / scan / file server are exactly the same.
3.3 Assigning an IP Address to the Server
3.3.1 Preliminary
„
If you have a DHCP server on your network, your Server will receive an IP
address automatically. The IP address will then appear on the Control Center
or on the page of configuration report that you printed earlier. If your DHCP
server does not give an IP address to the Server, the Server will use the
Default IP address: 192.168.1.100.
„
If you are not working in a DHCP network, you need to manually set the
Server’s IP address.
3.3.2 Ethernet Address
You do not need to know the Ethernet address of your Server for assigning an IP
address to it. The Control Center can automatically search Servers and list their
Ethernet addresses. Besides, you can find Ethernet address that is located on the
backside label of the Server.
3.3.3 IP Address
Unless you are assigning an IP address using DHCP, you must obtain an unused IP
address from your network administrator.
3.3.4 Methods for Setting the IP Address
You can set the IP address of your Server using one of the following methods,
depending on your network operating environment:
„
Automatic IP Address Assignment
„
Manual IP Address Assignment