TRENDnet TE100-MP1U - Manual (Page 60)

60
F. Then try to issue a print job to the desired printer. You will see the Control Center
will automatically do a connect operation. Then, the print job will be issued to that
printer. This is so-called “Auto Connect Print” operation.
G. Of course you can issue print jobs using manual “connect” and “disconnect” rather
than “Auto Connect Print”. To do this, click on the printer, then click the “Connect”
button. The name of the computer that has the ownership of the printer will be
shown after the printer in the Control Center. Now you can issue print jobs to this
printer. After all print jobs are finished, click the “Disconnect” button.
H. Even you already properly setup an auto-connected printer, the Control Center
must be running while a print job is issued. This means you’d better run the
Control Center every time after you login Windows. In order to skip this manual
operation, you can make the Control Center be run automatically after you login
Windows. To do this, choose the “Configuration” item in the “Tools” menu. The
following window will appear. Click on the check box and then on the “OK” button.
This feature is enabled by default.
I. If you would like to break the association between the Windows printer and the
physical printer, just click on the association and click the “Delete” button in the
“Auto-Connected Printer List”.
7.3.3 NetUSB Scanning
After the driver is installed as described in 7.3.1, you can see a newly created scanner
in the Control Panel’s “Scanners and Cameras”. Follow the steps below to do a NetUSB
scanning.
A. In the Control Center, click the MFP Server that has the desired scanner (or MFP)
attached.
B. Click the desired scanner (or MFP).
C. Click the “Connect” button to manually connect the scanner (or MFP).
D. Right-click the scanner icon in the Control Panel’s “Scanners and Cameras”, and
choose “Get picture using Scanner Wizard”, as the following figure.