TRENDnet TE100-MP1U - Manual (Page 17)

17
3.3.5 Server Names and Server Name Rules
The default server name of the Server is “TE100-MP1U” or “TE100-MP2U” or
“TEW-MP2U”. If you put two or more Servers in your local area network, to avoid using
the same server names you have to change the server names by using the Control
Center or the Server’s web pages. If your server name is longer than 15 characters,
the Server uses only the first 15 characters.
3.3.6 Setting the IP Address Using DHCP
Follow the instructions below to get an IP address using DHCP:
1. Edit or create a scope in the DHCP manager of the DHCP daemon. The entries
included in this scope should contain the following parameters:
y
range of IP addresses
y
subnet mask
y
default router IP address
y
DNS server IP address
y
lease duration
2. Activate the scope. The Server automatically gets the DHCP parameters. If you
are using DNS, you may include at least one DNS server IP address in the DHCP
scope or manually set the DNS server IP address using Server’s web pages or
the Control Center.
3.3.7 Setting the IP Address Using the Control Center
11. Install the Control Center. The Control Center is available on the Product CD.
12. Start the Control Center and Auto-searching Server window will appear.
13. If the tool finds multiple Servers in your local area network, then you have to
select one Server from the Server List.